Moxa AWK-3121-M12-EU-T Guia de Instalação descarregar pdf (Página 6)

- 6 -

Wall Mounting (optional)

For some applications, it may be more convenient to mount the

AWK-3121 to a wall, as illustrated below.

STEP 1:

Remove the aluminum

DIN

-Rail attachment plate

from the AWK

-3121, and

then attach the wall mount

plates with M3 screws, as

shown

in the adjacent

diagrams.

⇒

STEP 2:

Mounting the AWK

-3121 to a wall requires 4 screws.

Use the AWK

-3121 device, with wall mount plates

attached, as a guide to mark the correct locations of

the 4 screws. The heads of the screws should be less

than 6.0

mm in diameter, and the

shafts should be less

than 3.5 mm in diameter, as shown in the figure at the

right.

Do not screw the screws in all the way

—

leave a space

of about 2 mm to allow room for sliding the wall mount

panel between the wall and the screws.

NOTE

Test the screw head and shank size by inserting the screw into

one of the keyhole shaped apertures of the Wall Mounting Plates

before it is screwed into the wall.

STEP 3:

Once the screws are fixed

into the wall, insert the four

screw heads thr

ough the

large opening of the

keyhole

-shaped apertures,

and then slide the

AWK

-3121 downwards, as

indicated to the right.

Tighten the four screws for

added stability.

⇒

Wiring Requirements

WARNING

Safety First!

Be sure

to disconnect the power cord before installing and/or

wiring your Moxa AWK-3121.

1 2 3 4 5 6 7 8 9 10 11 ... 14 15

Comentários a estes Manuais

Sem comentários

Moxa AWK-3121-M12-EU-T Guia de Instalação Página 6

Comentários a estes Manuais