Moxa IOLOGIK W5340-T Manual do Utilizador descarregar pdf (Página 22)

ioLogik Cellular Micro RTU Controller Getting Started

2-6

5. Monitoring and Testing I/O status: Once your unit has been found by ioAdmin, you can view the status

of all attached I/O on ioAdmin’s main screen.

NOTE

ioAdmin supports four viewing options for the navigation panel. If you select “sort by Active OPC server,” the

ioLogik W5300 will appear in the Active OPC server group. Simultaneously, the same devices will be shown

under the <LAN> group if you connect to the W5300 with Ethernet cables instead of over the cellular network.

You can test each DO channel by opening the channel’s configuration window and selecting the Test tab.

After clicking the Test tab, you can see how a channel’s status affects or is affected by the attached device. For

DO channels, you can set the on/off status or start and stop pulse output. For DI channels, you can monitor the

attached device’s on/off status, or monitor the counter.

You can now use ioAdmin to set up or configure your unit. Refer to Chapter 3 for additional information on using

ioAdmin.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 195 196

Sem comentários

Moxa IOLOGIK W5340-T Manual do Utilizador Página 22