Moxa NPORT 5110-T Manual do Utilizador descarregar pdf (Página 47)

NPort 5100 Series Web Console Configuration

5-24

12 S11 DTMF duration and spacing (always=100 ms) no action applied

13 S12 Escape code guard time

(default=50, unit 1/50 sec)

to control the idle time for “+++”

TCP alive check time

Setting Factory Default Necessity

0 to 99 min 7 min Required

0 min: TCP connection is not closed due to an idle TCP connection.

1 to 99 min: NPort 5100 closes the TCP connection automatically if there is no TCP activity for the given time.

Local TCP port

Setting Factory Default Necessity

1 to 65535 4001 Required

The TCP port that other devices must use to contact this device. To avoid conflicts with standard TCP ports, the

default is set to 4001.

Reverse Telnet Mode

TCP alive check time

Setting Factory Default Necessity

0 to 99 min 7 min Optional

0 min: TCP connection is not closed due to an idle TCP connection.

1 to 99 min: NPort 5100 automatically closes the TCP connection if there is no TCP activity for the given time.

Inactivity time

Setting Factory Default Necessity

0 to 65535 ms 0 Optional

Idle time setting for auto-disconnection. 0 min. means it will never disconnect.

Local TCP port

Setting Factory Default Necessity

1 to 65535 4001 Required

Each of NPort 5100’s serial ports is mapped to a TCP port. To avoid conflicts with common TCP port numbers,

set port numbers to 4001 for port 1, 4002 for port 2, etc.

Map <CR-LF>

Setting Factory Default Necessity

CR, LF, or CR-LF CR-LF Required

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 93 94

Comentários a estes Manuais

Sem comentários