Moxa NPORT 5110-T Manual do Utilizador descarregar pdf (Página 51)

NPort 5100 Series Web Console Configuration

5-28

DCD changed

The DCD (Data Carrier Detect) signal has changed, also indicating that the modem connection status has

changed. For example, a DCD change to high also means “Connected” between local modem and remote

modem. If the DCD signal changes to low, it also means that the connection line is down.

When the DCD changes, the NPort 5110/5150 will immediately send an e-mail or send an SNMP trap.

DSR changed

The DSR (Data Set Ready) signal has changed, also indicating that the data communication equipment’s power

is off. For example, a DSR change to high also means that the DCE is powered ON. If the DSR signal changes

to low, it also means that the DCE is powered off.

When the DSR changes, the NPort 5110/5150 will immediately send an e-mail or send an SNMP trap.

Mail

Setting Factory Default Necessity

Enable, Disable Disable Optional

This feature helps the administrator manage how the NPort 5100 sends e-mail to pre-defined e-mail boxes

when the enabled events—such as Cold start, Warm start, Authentication failure, etc.—occur. To configure this

feature, click the Event Type Mail checkbox.

Trap

Setting Factory Default Necessity

Enable, Disable Disable Optional

This feature helps the administrator manage how the NPort 5100 sends SNMP Trap to a pre-defined SNMP Trap

server when the enabled events—such as Cold start, Warm start, Authentication failure, etc.—occur. To

configure this feature, click the Event Type Trap checkbox.

Monitor

Monitor Line

Click Line under Monitor to show the operation mode and status of each TCP/IP connection (IPx) for the serial

port.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 93 94

Sem comentários

Moxa NPORT 5110-T Manual do Utilizador Página 51